Skip to main content

Filter by idea status

Filter by product

6851 Ideas

Automatic recalculation of thread depth when changing hole depthUnder Consideration

When creating a threaded hole as standard hole in Creo Parametric using a *.hol filethe hole depth and the thread depth will be calculated initially with the following static formulars:DRILL_DEPTH = 3 x DRILL_DIAMETER                              for example: DRILL_DEPTH = 3 x 7 = 21THREAD_DEPTH = DRILL_DEPTH / DEPTH_RATIO         for example: THREAD_DEPTH = 21/1.25 = 16.8If the threaded hole was placed there is no more intelligence like this for further changes.The only rule is that the thread depth can not be deeper than the hole depth.If this happens the thread depth will be changed to the same value than the hole depth.With this behaiviour it es not possible to create an individual hole depth (not every hole is 3 x DRILL_DIAMETER)with an automatic change for the suitable thread depth.It would be nice to have the following behaviour to provide a higher level of automation for the customer creating standard holes:It should be possible to define the initial value or calculation rule for the DRILL_DEPTH inside the *.hol file for each single FASTENER_IDIt should be possible to define the blind-hole value (how much the hole is longer than the thread) inside the *.hol file for each single FASTENER_IDIt should be possible to define the DEPTH_RATIO for each single FASTENER_ID inside the *.hol file instead of one value for all holesIt should be possible to choose between the additional blind-hole value or the DEPTH_RATIOThe THREAD_DEPTH should always be recalculated when changing the DRILL_DEPTH:THREAD_DEPTH = DRILL_DEPTH - blind-hole value  (or THREAD_DEPTH = DRILL_DEPTH / DEPTH_RATIO if set to these option)The DRILL_DEPTH should always be recalculated when changing the THREAD_DEPTH:DRILL_DEPTH = THREAD_DEPTH + blind-hole value (or DRILL_DEPTH = THREAD_DEPTH * DEPTH_RATIO if set to these option)