Recently active
Don,I couldn't replicate the instructions.
Ruben,Did you make this in the Student version? I already made something similar. Show a close up of the corner using reflection analysis.
Tommaso,Go to the Tree Filters as shown in Figure 1. Then select Datum plane as shown in Figure 2. Apply > OK.Figure 1Figure 2Datum planes appear in Figure 3.Figure 3
Based upon your Method # 2, you're stating that everytime a cut is made on the yellow block, the surface will automatically be red?
Select the pull-down until you get IGES, as shown below.I didn't get any quilts in the import.
I've already downloaded that. I was under the impression that this part was being added to another assembly, based upon the model tree.
Terry,I imported the same part, and it came in as a solid (see below image).
Frank,Isn't the N-sided functionality for more than four boundaries? The corner blend has only three. BTW, the Product Development Team disabled this functionality, and you have to enable it to use it, as stated in the attached link.https://www.ptcusercommunity.com/ideas/5331
Hi Terry,If your assembly is not proprietary, and if you haven't resolved the problem, you can upload the assembly in this discussion for reviewing.
Terry,Import the iges as a solid, save it with a .prt extension, then add the .prt file to your assembly.
That's right. You have to select Import as solid as shown below.
Milos,They are using h-elements, and yes, they have problems using a plethora of tets. Creo Simulate uses the p-element, a more advanced smarter element. I've attached a memo from Dr. Ken Short to help explain this.
What does your convergence plot look like for the max von Mises?
It sounds like you've answered your own problem.
You might want to try posting this question under Academic > Schools Program (see below image). If you use Creo Simulate Lite, you don't need an additional license, but I don't know which version you're using.
Quick Check isn’t a convergence method since the model is run only for a single fixed (low) polynomial order (shown below p3-p3). The stress results should never be trusted. What a Quick Check is for is to quickly run the model through the solver in order to pick up any errors that have been made, for example in the constraints. A quick review of the results will also indicate whether any gross modeling errors have been made and possible to point out potential problem areas in the model.
Mixed mesh is not a problem, as long as it is set up properly. To expedite your studies, I would recomend running quick checks until you get the model to behave properly, then run a convergence analysis.
Steven,I replicated an example (below) using your instructions, and I didn't have any problems with merging, but my model is very simple.
Gautam,You cannot open a Creo 3.0 file in Wildfire 3.0.
Steven,Can you post images in relation to your procedure or attach the model?
Mani,Is your print-out a pdf file?
What version of software are you using?
Martin,Nice to know that there is some consistency in the date codes.
Hi Martin,I'm currently using Creo Parametric 3.0 M020. I created a model called 123 with the default template. I then set the absolute accuracy to 0.0075 and imported the model by Model > Get Data > Import.I couldn't get the model to import directly, you know, by File > Open > Import, so I tried the method above and it worked. It took some time to import, but it worked.
Already have an account? Login
No account yet? Create an account
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.