Skip to main content
Apr 8, 2015 5:41 PM UTC
Question

Re: importing iges/step assys into creo 2.0

Select the pull-down until you get IGES, as shown below.

iges.jpg

I didn't get any quilts in the import.

iges_1.jpg

    2 replies

    Apr 9, 2015 4:53 PM UTC


    thisisall.png

    Apr 9, 2015 9:59 PM UTC

    Terry,

    I think that tested IGES file was saved as Flat IGES (you can open some Creo assembly and save it as Flat IGES, too). Therefore it does not contain original assembly structure and you can open it as part, only.

    I have never used GET DATA/IMPORT in Assembly mode, therefore I do not have any knowledge in this area.

    When you use GET DATA/IMPORT in Part mode, you will get solid model (containing geometry saved in tested IGES file).

    Martin Hanak