Recently active
Can anyone explain why a longer sketched curve will shift off the csys after wrapping whereas a much shorter curve will not?
I've had to import STEP assemblies from the past (using PTC versions prior to Creo Parametric), and many times I've had to take the existing imported quilts, copy them, and then paste them onto the existing locations. Once you perform this, they are now workable surfaces.This is why I would suggest trying to solidify a single part before attempting an assembly or try to solidify one of the parts within the assembly.What version of Pro|E are you using?Can you upload a screenshot of your assembly, including the model tree?
Harish,Try to solidifiy a single surface STEP file. The below images show how to solidifiy an imported STEP surface.1. Import the surface STEP file:2. Select the surface to activiate the Solidify icon:3. Select the Solidify icon then select the green check mark:You should have a solid part.
Lawrence,Thanks for the comments, and I couldn't have said it better myself. I didn't go into the differences between the p and h element methods, but I'm well aware of the differences. I'm looking forward to the revised demo. The original video was good, and I promote Creo's AutoGEM controls a lot. However, end-users should look at the solutions with convergence to determine if refinement is really needed. AutoGEM controls can useful for interferernce fit contact problems, as I use it to create layers of brick elements, even though it's still the p-method.
Creo Parametric currently does not have the capability to create a plane by equation (Ax + By +Cz + D = 0), out of the box. This functionality exists in CATIA, and can be very useful when creating offset planes. However, it can be created as a User Defined Feature. Siemens NX also has this capability.The CATIA GUI is shown below, and is very simple to use.Creo Parametric can create a plane by equation using relations as shown below. But it's much easier and faster to be able to just enter A, B, C, and D and select the coordinate system and create the plane.
If I understand your question correctly, you want to mark the center of gravity (c.g.) in your model (I think you called it "center of weight").While in the standard application, run the mass properties to find out where the c.g. is located.Notice the coordinate for the c.g. and make a datum point at that location.Name the point CG or whatever label you would like to call it. This will mark the c.g. in the model.I hope you found this helpful.
Already have an account? Login
No account yet? Create an account
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.