Skip to main content
Aug 20, 2013 5:29 PM UTC
Solved

Wrapping Rotor Blade Curves from Sketch - Wrapped Curves Shift

Can anyone explain why a longer sketched curve will shift off the csys after wrapping whereas a much shorter curve will not? 

 

 

Aug 20, 2013 6:52 PM UTC

CS didn't know this? I had a real problem with this and I only learned of it through some tutorials. There are a few other features that are reliant on this... I think toroidal bend also requires a CSYS in the sketch.

8 replies

Aug 20, 2013 5:56 PM UTC

Wrap uses the extent of the sketch to determine a center -if- you don't have a local CSYS in the sketch. I -always- use a CSYS in the sketch for wraps.

Aug 20, 2013 6:37 PM UTC

Thank you for the advice. 

 

 

Aug 20, 2013 6:47 PM UTC

Nonono... you cannot use this option -unless- there is a CSYS in your sketch. Once the CSYS is included in the sketch, the option will not be grayed out and you will need to use it (it should select this by default after that).

csys_in_sketch.png