Skip to main content
May 16, 2012 12:07 PM UTC
Question

Re: How can i mark on the modeling's center of weight ?

If I understand your question correctly, you want to mark the center of gravity (c.g.) in your model (I think you called it "center of weight").

While in the standard application, run the mass properties to find out where the c.g. is located.

Notice the coordinate for the c.g. and make a datum point at that location.

Name the point CG or whatever label you would like to call it. This will mark the c.g. in the model.

I hope you found this helpful.

    1 reply

    May 17, 2012 7:11 AM UTC

    Hi Steven

    What you have suggested is correct.But it will not change the COG dynamically when dimension of part is modified.

    But the process suggested by Srinivasaniyer; will change the point(COG) dynamically when you change any dimension of the part.

    So it is up to you to choose the process that suits you best to create COG

    Regards

    K.Mahanta