Recently active
You have probably figured this out by now, since this post is over a year old. But the way you move the text is illustrated below. Open up the dimension properties by double clicking on the dimension with the LMB, and you can Move or Move Text.
100% sure. For some reason, there was a disconnect between the true Standard Orientation and Ctrl+D, something beyond my understanding. But it happened, and now it's "corrected".
After selecting Ctrl-D, the assembly will not go to the default orientation view, but rather it will show an end view. Also, after selecting the Default Orientation with the LMB, it goes to an end view. Has anyone else experienced this?
Thanks Tom.
I was able to restore Ctrl+D to Standard Orientation by the below orientation steps then save. Now when I perform Ctrl+D, it will snap to the correct position (Standard Orientation).
Ctrl+D is giving me Figure 1 below, but it should be like Figure 2.Figure 1Figure 2
My Standard Orientation is the same as Figure 1.
After taking another look at your posted image, it seems that Creo would have no difficulty in making surfaces on the sections and curves.
You can set the Default Orientation by highlighting Default Orientation and select Set (shown below), and you can place the view back to Default Orientation using Saved Orientations. But Ctrl-D still won't place the view back to default. How can I get Ctrl-D to work again?
PTC is also investigating this problem (PTC Case Number 13191064).
This problem occurs in the exploded view of a 3D assembly, not in drawing mode.
Ketan,Try this. I created an IGES file from your test part simply by selecting the following geometry option in the export IGES dialog. This is the simplest and quickest way. You don't need to use Copy/Paste to achieve this.
Perhaps you could use control points to prevent that.
Even if Creo could flatten the oil pan, this would not give you the amount of material required for the deep drawing forming process. If you don't already know how it's made, I've attached a white paper on this very subject. After the oil pan has been formed, a laser trims off the excess material.
Are you trying to make leaders in model mode or drawing mode?
It appears to me that you could Boundary Blend the curves in your attached image.
That was the only drawback I saw, that is, the attached instructions are for Boundary Blends, not Swept Blends.
John,Someone posted a real-world problem today concerning influencing curves.https://www.ptcusercommunity.com/message/461206#461206
Paul,I've attached some instructions on how to use influencing curves along with the two models used in the instructions. I haven't attempted this with your type of problem, and I hope this will give some insight.
You have now uploaded three different models:1. testpart2. updateda3. updatedI provided solutions to testpart and updatea. I have no idea what you're trying to say concerning updateb. The problem I'm having with this thread is that you keep changing/uploading different models instead of trying to solve one model.
Doesn't the first surface contain the outline highlighted in green? See below image.
The first surface is the entire outline, so that's all you need.
I took your part, save it as another prt file, then deleted the bottom two surfaces before exporting.
This one should do it.
I've attached the IGES. All you have to do is delete the bottom two surfaces in the model tree and save it as a wireframe.
Already have an account? Login
No account yet? Create an account
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.