Recently active
Add 3rd order continuity (constant rate of change of curvature/ G3 continuity) to ISDX to be competitive with other Class-A-Surface modeling software.
This is now available in Creo 4 ISDX.
Hartmuth,Don't forget to vote for yourself.
Roland,Increasing the RAM is something I brought up four years ago to product development, as discussed in the attached thread:https://www.ptcusercommunity.com/ideas/2424
You may already know this, but if you would like a better understanding of .obj files, read this:https://en.wikipedia.org/wiki/Wavefront_.obj_file
You cannot mesh the file. Why don't you just make a sphere in Creo? Or do you need all those faces?
After exporting a drawing file to pdf, I noticed that the edge lines vary in thickness. Is there a fix for this?
Which happens to be M120.
When I print the drawing on paper, all the lines are uniform.
Okay....then how can it be in the export data?
I used CTRL + 5 and that corrected it. So it must be the reader and not the export settings.
The image I attached is at 100%, and the lines are very obvious. At 400%, it almost disappears.
David,Acceleration connections (G3) only comes with Interactive Surface Design (ISDX), as shown below. The new Creo 4 Help Center under What's New, has a demo for G3.
Use the latest date code.
I think you cannot mesh it because you don't have a 3D solid part. To test this, try to cut open the part with the extrude feature.
Hello Babu,After creating surfaces, I would recommend running a reflection analysis to check for continuity. You're using Creo 3, and I have attached a screenshot in Creo 3 to show you where to use it. Creo 3 only goes up to G2, but with Creo 4, you have G3 capability. You will notice a slight disruption in the reflection lines. With Creo 4, you should be able to smooth this out.
Thanks.
I will work on this next week.
Scroll up until you see my Dec 7, 2016 post. It's attached.
Israr,I cannot retrieve your model, as shown below. I'm using Creo Parametric 3.0.
If you have access to YouTube, there are a lot of free videos that are very helpful and will show you the basics.You can view free videos from PTC at:http://learningexchange.ptc.com/BWIR has free webcasts at:http://www.barry-wehmillerinternational.com/user-resources/webcastsYou can sign up for these free webcasts, plus they're on YouTube.
No I don't. Why pattern it in sketch when you can pattern a hole after you exit sketch?
It's even worse in sketcher mode.
Dustin,The Intelligent Fastener Extension (IFX), Lite Version, is included with a purchased of Creo Parametric, and is located under the Tools tab as shown below. It was not developed by PTC, and is a B&W Software product. The Lite Version has a plethora of hardware, however, if you have a fastener that is not in the library, you can customize your own, but this will require the Full Version for an additional fee. I have attached a PowerPoint showing the differences between the two. I am currently working on adding a customized fastener, the NAS624, which has a 12-point head. B&W Software continues to add hardware to their library, and they currently have 10 hardware catalogs. We purchased the Full Version last year.
Are you working with an imported model? Are you allowed to upload the model, providing it's not a student version? Welcome to the forum.
Already have an account? Login
No account yet? Create an account
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.