Skip to main content
Jan 31, 2017 8:03 PM UTC
Question

Re: Creo 3 Surface gap filling

Hello Babu,

After creating surfaces, I would recommend running a reflection analysis to check for continuity.  You're using Creo 3, and I have attached a screenshot in Creo 3 to show you where to use it.  Creo 3 only goes up to G2, but with Creo 4, you have G3 capability.  You will notice a slight disruption in the reflection lines.  With Creo 4, you should be able to smooth this out.

reflection_analysis.jpg