Recently active
Can you use "old school surfacing" with Creo 2?
Correct.
Tom,The McAfee Host Intrusion Prevention tool is preventing the creosvcs_64.exe from installing Creo 4 and Creo 3 updates (error message below). I talked with our IT lead this morning, and he performed a remote logon to confirm it. It is blocked due to a new internal policy. Our IT department has submitted a request to allow permission to install Creo on this particular PC, unique to the computer name. This is the proposed fix.
Creo Simulate Lite should come with Creo Parametric, but not the full Simulate version, and you can use some simulation if you don't have the simulation license. Check your license file, as shown below. I have the basic and advanced licenses.If you don't have the licenses, you should be able to run the Lite version.
Jean,When you're done with modeling, it should look like the image below. I have attached a STEP file that you can import and use as a guide.
Thanks.
Hi Jean,The PTC Community has an academic section that you may want to consult with. Please see the below image for guidance.
I moved a hole using FMX, but the axis did not move with it. Is this the norm or does the function need correction or neither? Thanks in advance.
Sounds like someone has a similar problem with Creo 2.https://www.ptcusercommunity.com/thread/142421
Hello Joshua,I recommend starting a post in the System Administration forum or the Academic Support, as shown below. Did you install a 64-bit version? Welcome to the forum.
I inserted the image and scaled it according to the given dimensions. The rest was traced, because there were no dimensions for the rest of the geometry, for example, angles.
What version of Java are you running and are you using a commercial or student version of creo?
The split lines can also be seen in Creo View Express 4.0, and in this version, there is no way to "remove" them. I cannot place a support ticket for the express version. But I know it shows up in the free version too.
That's an inserted image that has the red dimensions.
Jean,Use the Revolve tool to make the pulley, as shown below. Make one hole and pattern it.
Hi Jean,I can help you with this. What units are you working in and do you have a commercial or student version of Creo? If so, what version? Welcome to the forum.
Thomas,What's new in Creo 4.0 is listed in the Help Center CD, as shown below after installing.
MH,You mean several releases like in the below screenshot? And I should have an environment variable for each?
Is it possible to add fasteners on curved surfaces? I tried this, but it would not work.
The top is 0.400", but does it stay continuous all the way down? You can make a variable round to follow the curve.
Is this a real-world problem, or just something to test Simulate's capabilities? Do you have a photo of the actual part/assembly?
Roland,Please see Dr. Jakel's attached presentation on contact starting with Slide 91 for how unreliable contact is using Simulate.
What's New in Creo 4.0 is listed in the Help Center, and there is a demo on G3. What do you think about this...Dean?Creo Parametric Help Center
Can you upgrade to Creo 4?
Already have an account? Login
No account yet? Create an account
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.