Recently active
If you change the file extension from .zip to .txt, it will go through, then the receiver has to change it back to .zip.
While in Sketcher, select Sketch Setup as shown below. You may change the sketching plane through this function.
As far as I know, it does not.
Jagan,Are you wanting advice on four different topics?Curves from cross-sectionGraphsRibbonReferences
Andy,When a material is assigned from the materials library, it becomes part of the input file, and it also remains in the library. If you open another part and decide to assign the same material to that part, that material will still be in the materials library to be assigned.
Huruj,Here's another video:https://www.youtube.com/watch?v=ti1vYk6vGy8
You can export Creo models for Abaqus, as shown in the attached video:https://www.youtube.com/watch?v=bFpPVhPTeRY
Can you post an image and mark your post as correct?
Patrick,It's called Creo Simulate (formerly Pro|Mechanica, and before that, Mechanica). The original Mechanica, created by a company called RASNA, Inc., was aquired by PTC, and PTC integrated it with Pro|Engineer.
.
You're right, but the functions are the same.
Go back to Creo Parametric, open the component with the volume regions and go back into Creo Simulate with just that component, then try to delete them.
Anders,Go to the Simulation Feature in the model tree where the volume region was created, RMB, then delete. See the below image for clarification.Welcom to the forum.
Huruj, We're these links helpful?
Maybe the attached spreadsheet will help.
Glad to help. I saw in your original model the discrepancies that you described, but I'm glad you got it figured out.
If you can save this as a STEP file with the points and curves, I can import it.
Got it and voted up!
For now, I could only find the Snap Line functionality for 2D drawings, as explained below:
Patrick, The one hint that I have is that the spreadsheet follows the formulation of a NASTRAN RBE3 element.
Luis, Are you referring to Explode Lines?
If this was made in a commercial version, you may upload the model, and we can take a look at it.
Frank, I assume you want to add points to a spline, then use those points to move the spline? While in Sketch Mode: Double-click the Spline with the LMB to access Edit mode Right-click on the spline and select Add PointYou can add as many points as needed. See figures below:Figure 1: Double-click Spline in Sketch ModeFigure 2: RMB-click Spline in Edit ModeFigure 3: New Point Added
David, Why would PTC need a requirement from Microsoft? You lost me on this one.
Können Sie das Modell schneiden? Welche Software benutzen Sie?
Already have an account? Login
No account yet? Create an account
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.