Skip to main content
Feb 2, 2015 9:19 PM UTC
Question

Re: Adding pull points to a spline.

Frank,

I assume you want to add points to a spline, then use those points to move the spline?

While in Sketch Mode:

  • Double-click the Spline with the LMB to access Edit mode
  • Right-click on the spline and select Add Point

You can add as many points as needed. See figures below:

spline_1.jpg

Figure 1: Double-click Spline in Sketch Mode

spline_2.jpg

Figure 2: RMB-click Spline in Edit Mode

spline_3.jpg

Figure 3: New Point Added

    2 replies

    Feb 2, 2015 9:40 PM UTC

    Thanks so much for the help.

    Feb 2, 2015 9:43 PM UTC

    Glad to help.