Recently active
What software and version are you running?
The ASUS ROG G551JM is not supported by PTC, which no doubt, has a gaming video card. You may be running the same software, but perhaps different hardware, especially the graphics card.
The Help Center will explain these functions.
Duplicate post.
Can you provide some images of the system?
That depends on the size and shape of the container, and the sizes of the marbles. Can you provide the required information?
I don't know of a way to check the maximum stress for every element, like you can with StressCheck, just the min and max. And I don't know of a way to show all the load cases at once, which would be a nice enhancement. However, I can show the maximum stress in the component for all load cases in one GUI with three result windows side-by-side, as shown below. But I don't think this is what you're looking for.
If you will place your cursor over Reflection and press F1, it will open the Help Center to explain how to Reflection. The same goes for Knots and Slope.
Without sketches or photos, it's difficult to determine how to constrain.
Creo Simulate uses the p-element where the fidelity of the solution is increased by increasing the polynomial order, not the number of elements.
Can you post the solution with images?
Don,Creo Simulate will not refine the mesh automatically during a run unless the following conditions are met:
When you say "fasteners", are you referring to the advanced fastener tool?
Kay,If I'm reading your task correctly, all you have to do is copy the desired external surfaces and thicken it 2.5 mm. Here are some images that may help you.Figure 1: Original model to copy surfaces fromClose model in a known directory. Figure 2: Copy geometry from original modelFigure 3: Open the reference model to copy surfacesFigure 4: Activate surface sets collectorFigure 5: Select desired surfacesFigure 6: Copied surfacesFigure 7: Thicken surface outward
Hi Kay,Did any of these responses help?
That's a graphics problem, not the Fill and Boundary Blend functionalities. That happened to me back around 2002, same thing.
Good tip. Placing a negative value will move the shell outwards, even though it shows a positive number after entering. This is much faster then copying surfaces. Thanks for posting. I have to use geometry copy a lot because of aircraft repairs. It's good to know faster methods when needed.
Good information.
Hi Kay,Just curious. Why did the company switch from SW to Creo?
You need a creo 4 license to run creo 4 and previous versions.
I haven't used WF5 in a long time, but you can add as many models to a drawing as needed. For example, the below image is from a simple drawing I had to make for an engineering disposition. This drawing consists of two sheets. The first sheet has the flat pattern, and the second sheet has the bend view and iso view. However, there are three separate models to represent three different views. Notice the number of models boxed in red.
You're welcome.
Related topic. How Many Votes Does It Take? - PTC Community
You cannot view acceleration load by this method. I have performed many gravity simulation studies, and I always assign the right material properties to each component, sum them in a spreadsheet, and compare it to the results in the run summary file after checking Output>Reactions.
Are you referring to the Style tool in ISDX or the Freestyle tool?
Already have an account? Login
No account yet? Create an account
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.