Recently active
wtai,I assume you're using a student version of Creo? Correct? If not, would you upload the planes? I tried to orient my spin center similar to yours with a curve on a plane. Welcome to the forum.
How many points did you make with the SW spline? I looks like 2.
That's the way PTC configured it. All the other styles are in the pull-down menu, but they left the "filled" out.
Yes, you can change the element colors, and the image I posted has the default colors for shell elements.
Are you the same Louis Gary Lamit that wrote the Pro|Engineer and Creo books?
How can you adjust the leader length on the leader that is opposite of the elbow leader?
Can you share the model?
These are the colors I get.
That's what it is. But the colors I've always seen are two different shades of green, not green and red.
Sharath,I think you will have to create your own triangle symbol with a number in it. Here's the instructions on how to do that.
PTC, please create a way to set your working directory in Creo Illustrate. This would be very helpful.Thank you!
Windows 10 is supported in Creo 3.0. Supporting data attached.
You're right. I'll drop the idea from the Community.
Which Creo version? 1.0, 2.0, 3.0? Student or Commercial version?
Thanks Shane. That's why I tried, but I didn't know to use @O. So I learned something new today, as I don't do many drawings.
Doug,Is that really a spline curve or is it a conic curve that can be snapped tangent to a construction line?
The correct way:
Sharath,The only way I know to make a note as shown in your example is depicted below, which doesn't seem to be common practice in Creo. It's almost as if you want to dimension a part except have a note instead of a value. Also, you cannot detach the blue vertical lines from the part. The way I made this is:Annotate > Note > Leader NoteSelect LH side of partHold CTRLSelect RH side of partMake noteReactivate leader lines and move cursor over ends until you see a little black boxDrag leaders to desired positions
Denis,Why are you concerned about the arrow?
Denis,The four interfaces represents the four contact zones (shown below).1. One contact between the glass and the support2. Three contacts between the glass and the rounds on the support.You can rename the contact zones.The arrow in the middle is the icon for a 1g gravity load (shown below).
Adding Warp.Welcome to the forum.
Brian,I think you want to create a pipe as shown below. There are several ways you can make this. Since you already have the curves, you can select the desired curves with the Project icon as Martin suggested. Or you can create the curves in Sketcher Mode, as I did below. Either way will work.Now trim the unwanted curves.
Marco,You change the units to MPa (mm-N-s) for the linearized stress report in the model properties before running the analysis. The below report has units of MPa.
Nice work.
What two responses? What specific results are you looking for?
Already have an account? Login
No account yet? Create an account
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.