Skip to main content
Jan 4, 2024 12:24 PM UTC
Question

Diamond screw mechansim

Diamond.PNG

 

I am using Creo Parametric Release 7.0 and Datecode7.0.2.0

What is the best way to set up a diamond screw for mechansim design? The principle is a helix groove in the shaft and a "knife" or tap in a follower to drive the follower over the distance of the groove. I tried using cam follower over a curve in the helix, but it will only take a partial of the length of the screw.

Anyone tried something similar or have any ideas?

1 reply

Jan 8, 2024 6:54 PM UTC

Hello,

Please refer to article : https://www.ptc.com/en/support/article/CS27684