Skip to main content
Oct 10, 2014 8:02 PM UTC
Solved

Modelling a suction cup

Is is possible in Creo Parametric to motion model the flexible part of a suction cup?

Thanks in advance.

Steve

    Oct 12, 2014 6:24 PM UTC

    Steve,

    Is this what you are after? The offset of DTM1 controls the 'squash' of the cup shown below as a section.

    Up.PNG

    Down.PNG

    Model attached.

    1 reply

    Oct 12, 2014 6:24 PM UTC

    Steve,

    Is this what you are after? The offset of DTM1 controls the 'squash' of the cup shown below as a section.

    Up.PNG

    Down.PNG

    Model attached.