Skip to main content
Nov 4, 2021 11:25 AM UTC
Question

I had got an error while performing static simulation

Hello community members,

I had got an error while performing static simulation. Could you please help me from this problem

 

Error stating " 

The design study terminated abnormally.
The model is insufficiently constrained for the analysis.
Please review the element connections, properties, and
constraints. If this is a modal analysis, then you may
be able to obtain a solution by requesting additional
modes."

 

i had attached image of it 

 

waiting for your response

 

Thanking......

2 replies

Nov 4, 2021 1:13 PM UTC

What version of Creo Simulate are you using?

 

Here are some helpful articles:

 

 

Also, there were similar questions before: 

Nov 4, 2021 1:18 PM UTC

i am using creo simulate 7.0