Skip to main content
Oct 27, 2021 11:35 AM UTC
Solved

CREO Simulate 7.0

Hello,

 

I had created profiles using the Bosch Profiles in creo 7.0 and then i am simulating it in creo simulate 7.0 but i found some errors. could anyone please help me.

VladimirNAnswer
Oct 27, 2021 5:34 PM UTC

Here's the article - "Mesh creation in Creo Simulate fails with message: "AutoGEM may not be able to complete because the volume boundaries either intersect or overlap near the highlighted surfaces" ": https://www.ptc.com/en/support/article/CS115533

2 replies

VladimirNAnswer
Oct 27, 2021 5:34 PM UTC

Here's the article - "Mesh creation in Creo Simulate fails with message: "AutoGEM may not be able to complete because the volume boundaries either intersect or overlap near the highlighted surfaces" ": https://www.ptc.com/en/support/article/CS115533

Nov 4, 2021 11:28 AM UTC

This solved me from error by using contat Interferances