Skip to main content
May 12, 2025 8:36 PM UTC
Question

Creo 10 - Hiding Edges in Section View

Hello,

 

Is there a way to hide or turn off visible edges in section view, when rotating models around?  When turning away from the cut side, the edges of the part(s) are still visible, and this can be very annoying.  Please see example image attached.  I have already tried going through all settings and Config editor, and cant find anything relating to this.

 

Thank You!

4 replies

May 13, 2025 12:14 PM UTC

Hi,

AFAIK the outline of x-section is always visible. You cannot turn it off.

May 19, 2025 4:29 PM UTC

Hi @CC_2846,

 

I wanted to see if you got the help you needed.

If so, please mark the appropriate reply as the Accepted Solution. It will help other members who may have the same question.
Of course, if you have more to share on your issue, please pursue the conversation. 

 

Thanks,
Anurag 

CC_2846Author
May 19, 2025 4:34 PM UTC

Only one answer, and did not help me to solve my problem.  Perhaps my issue cannot be fixed, but would like someone from PTC to chime in if possible.

May 20, 2025 5:38 AM UTC

@CC_2846 wrote:

Only one answer, and did not help me to solve my problem.  Perhaps my issue cannot be fixed, but would like someone from PTC to chime in if possible.


Hi,

if you would like someone from PTC to chime in then you have to open a Case at PTC Support.