Plastic Injection Molding - How to address common design problems
- 0 replies
- 954 views
Most common problems faced by designers are not during the design stage, but it's usually after the reviews. When a designer sends a design for validation to manufacturing, he/she starts receiving feedback on changes based on manufacturing setup. It is very difficult for a design engineer to track changes happening at manufacturing end and keep updating it with updated features. For example, to know which new injection molding machine has been installed, it's capacity and capability to produce material with thickness and avoiding problems like sink marks, undercuts etc.
This creates many iterations in design process and designer has to spend lot of time on correcting such problems. Further for a multinational organization the design and manufacturing are not co-located. Hence to have reviews on regular basis is not only difficult but also addressing such design problems is almost impossible. The design standard would change by region location, manufacturing setup, material used and many such parameters.
However, with advent of CAD platforms like Creo and improved modeling interface and capability updating model with all such inputs has become very easy. However manufacturability of a design still remains a 'Grey area' in design, as it depends on knowledge of design engineer about manufacturing setup of a given organization.
By using innovative tools like DFMPro manufacturability aspect of plastic injection molding problems. For plastic components some common problems can be addressed like :
- Undercuts
- Sink marks due to variation in wall thickness (differential cooling)
- Draft Angle
- Boss parameters
- Rib parameters etc
The parameters required for each check can be configured and after that just clicking a button the designs can be validated and you can generate reports. The reports are availbe in both 2D and 3D format and compact and easy to mail and helpful to collaboration.
This makes design engineer to focus on creative and core design aspects rather than doing mundane 'checking' activity!
