Skip to main content
Jan 10, 2024 7:29 AM UTC
Question

Logfiles for MatchCAD 7.0.0.0 License Utility

Hi all,

 

I've got an issue with licensing MathCAD 7 Prime. When starting MathCAD 7 Prime, only the express version shows up. After selecting the correct license in the License Utility, the utility software states, that MathCAD 7 Prime was successfully activated. After closing the utility, MathCAD 7 Prime restarts in the express version again while showing the dialog to enter a valid license.

 

Looking into the file C:\ProgramData\PTC\Mathcad Prime\MathcadPrime.exe.V7.Config, the property "LicenseType" is set to "NoLicense".

 

Entering the license using the license manager was tried in two different ways. With directly providing the license file and with a license server. The result stays the same, the utility software states a successful activation. After MathCAD restart, no license is active...

 

Is there any logging for the licensing process of MathCad 7 Prime available?

 

Thanks

3 replies

3-Newcomer
Jan 14, 2024 9:25 PM UTC

As far as I know, the Prime license is tied to the MAC address of your internet connection. If you have both a network card, and a WiFi connection active, your PC might be switching between the two, while the Prime license is only valid for one of the two.

Hope this helps.

Success!
Luc

 

Jan 15, 2024 1:00 PM UTC

I know that this is the case for the license server. We have a license file that is tied to the MAC address of the license server. Other machines activate their MathCAD installation via this license server. Also, these computers only have a single network interface.

So, unfortunately, this is not the solution for our problem.

 

As I pointed out, MathCAD restarts directly after activating the license. The restarted MathCAD is, however, not licensed... It seems that there is a problem during the installation process.

Jan 15, 2024 5:51 PM UTC

I recommend you open a new Case here - "Open a Support Case": https://support.ptc.com/apps/cs_loggers/case_logger/auth/ssl/log