Skip to main content
May 28, 2015 12:02 PM UTC
Solved

Who out there is thread milling in Creo 2.0?

I'm in the process of developing a thread milling process but I am not getting the correct tool path.  I need a single pass tool path but I'm not able to find the right parameter combination to get single pass. I using a solid tool defined in Creo to simulate a multi-tooth cutter.


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
ejwAnswer
May 28, 2015 12:30 PM UTC

Rick

I think the thread milling tool is the problem. In PTC's infinite wisdom flutes are not flutes for a thread milling tool. Flutes are the number of thread profiles on the tool. Measure the lenght of profiles and divide by the pitch of the thread. Round to a whole number and put this in the "number of flutes" for the tool. This should change the number of turns the tool makes.

Ed

2 replies

ejwAnswer
May 28, 2015 12:30 PM UTC

Rick

I think the thread milling tool is the problem. In PTC's infinite wisdom flutes are not flutes for a thread milling tool. Flutes are the number of thread profiles on the tool. Measure the lenght of profiles and divide by the pitch of the thread. Round to a whole number and put this in the "number of flutes" for the tool. This should change the number of turns the tool makes.

Ed

rcordovaAuthor
May 28, 2015 1:45 PM UTC

Ed, you nailed it!  Thank you for your quick response.