Skip to main content
Oct 19, 2015 8:57 AM UTC
Solved

ptc creo 3 - ramp angle

dear friends;

we are using creo 3 for cam programming , in roughing program although I mentioned ramp angle as 5 degree /less than 90 , cutter directly plunging on the material with out taking any ramp, does any one know the reason ? I am using volume and window .

RaphMORINAnswer
Oct 19, 2015 3:29 PM UTC

Hello, if you're using the new volume milling sequence you must specify a ramp entry. With the old volume sequence (Creo 2 and before) we didn't have to specify this, as soon as we were defining a ramp angle, the approach movement was a ramp.

9 replies

Oct 19, 2015 1:56 PM UTC

if you use this site file and then change the ramp angle from 90 to 3 degrees it should work. If you want a helical entry change the "helical_diameter" to whatever diameter you want. If you want ramp then change that to "0"

RaphMORINAnswer
Oct 19, 2015 3:29 PM UTC

Hello, if you're using the new volume milling sequence you must specify a ramp entry. With the old volume sequence (Creo 2 and before) we didn't have to specify this, as soon as we were defining a ramp angle, the approach movement was a ramp.

Nov 2, 2015 5:49 PM UTC

Hello Sreemesh,

did you try the suggestions? Did they help?

Please consider marking posts as correct, if they help you solving issues (only one allowed per thread, so you have to decide, if multiple posts are helpful)

Thanks,

Gunter

Nov 23, 2015 10:47 PM UTC

it is not solved

Dec 17, 2016 9:48 AM UTC

This is a correct solution thank you.

Jan 24, 2017 11:21 AM UTC

ramp angle.png

refer the above image and change it the tool will move according to the entry which you are going to select