Skip to main content
Mar 19, 2016 2:36 PM UTC
Solved

Play Path

We just switched to Creo 2 and I am struggling with play path. I used to be able to do play path, pick the file name and a it would open a dialog box that I could control the speed. It will still open the box if I go through the Process Manager. It will still run my CL file but I cannot control the speed so it goes real slow.What am I missing?

Thanks Bernie

    Mar 23, 2016 4:12 PM UTC

    oh i understand now you can also highlight just the sequences you want in the model tree and play those.

    New Picture (2).bmp

    6 replies

    Mar 21, 2016 12:22 PM UTC

    Bernie,

    I think that the cutting feed is too slow.  Maybe you made a mistake by defining the "cut data" for you tool and you entered 0.1 mm/min in stead of 0.1 mm/tooth.

    Then the feed is very slow and you can not accelerate it enough by the sliding bar.

    Jef

    Mar 23, 2016 2:09 PM UTC

    Instead of play path from a CL file move over to the model tree right click on the operation and click play path.  That will allow you to control your speed with the slider.

    pgf545Author
    Mar 23, 2016 3:28 PM UTC

    Thanks Nick, I have been doing that with no issues, but sometimes I will only do a CL file for a few sequences (set) and that is where the issue is. I used to be able to do it in earlier versions but I guess Creo2 doesn't do that anymore.

    Mar 23, 2016 4:12 PM UTC

    oh i understand now you can also highlight just the sequences you want in the model tree and play those.

    New Picture (2).bmp