Skip to main content
Feb 5, 2023 12:07 PM UTC
Solved

If Mitsubishi M80/M70 CNC controller can integrate with Kepware directly?

Inside Mitsubishi M80 CNC controller, one Q series PLC is used.

Inside Mitsubishi M70 CNC controller, one QnA series PLC is used.

 

Then I setup Kepware configuration and PLC program under the help of Mitsubishi Ethernet Driver Help, there have some contents about  Q and QnA series PLC, but I can't connect to M80 and M70 controller successfully.

 

So I want to confirm if Mitsubishi M80 and M70 CNC controller can integrate with Kepware directly?

 

cmoreheadAnswer
Feb 6, 2023 8:45 PM UTC

@SQ_10578950

 

Unfortunately, Kepware does not currently have a solution for communicating with M80/M70 series directly.  An alternative solution would be to use a Q Series PLC as a gateway to the M80/M70 series devices.  Please submit a case as described in the following link; if you would like to see if the functionality of a direct connection can be added to future releases of KEPServerEX:

 

https://www.ptc.com/en/support/article/CS295047

 

Thanks,

*Chris

2 replies

cmoreheadAnswer
Feb 6, 2023 8:45 PM UTC

@SQ_10578950

 

Unfortunately, Kepware does not currently have a solution for communicating with M80/M70 series directly.  An alternative solution would be to use a Q Series PLC as a gateway to the M80/M70 series devices.  Please submit a case as described in the following link; if you would like to see if the functionality of a direct connection can be added to future releases of KEPServerEX:

 

https://www.ptc.com/en/support/article/CS295047

 

Thanks,

*Chris

Feb 7, 2023 3:53 AM UTC

Thank you for your information.