Skip to main content
Jul 23, 2016 4:20 AM UTC
Question

Step AP242ed1 exporter

Hi all,

This discussion is about neutral file exporter (STEP AP242) in the Sneak Peek.I have tried many times to put some annotations on the part in the sneak peek version .

I put annotations from Creo 3 (in blue circle). Then I continued to put additional annotations from Sneak Peek (Red circled). Then the file was exported to step (ap242) format.

Capture Creo 23 July.JPG

I opened the exported file in a free viewer. From Sneak peek, it showed only dimensional tol, but geometrical tol. annotation was lost. Both annotation made from previous Creo is fine.

So this case points to step neutral file (ap242) capability in sneak peek.

Viewer AP242 23 July.JPG

2 replies

Jul 25, 2016 2:01 PM UTC

We're still working through fixing a number of issues (bugs) with the STEP exporter by the time of F000 later this year.

Mark Fischer‌ might be able to add some more comments here.

Jul 25, 2016 6:57 PM UTC

Hi Rivai,

We have reproduced the issue you outlined and we are diligently working on a solution.  As Raphael stated, we are still working through a series of use cases and resolving discovered issues.  These items will be resolved by the launch of Creo 4.0.


Regards,

Mark