Skip to main content
Jun 20, 2016 2:58 PM UTC
Question

Sketcher scaling automatically with first dim change.

I was hoping to see a few changes that I think are good features. There is one feature that I like about SolidWorks and that is the fact that after you sketch out what your extrude is going to be, you add a dimension and it is smart enough to know that when you change that dimension you want to scale the entire sketch. I hate the fact that Solidworks makes you add all your dimensions, this is a positive to Creo that they pop on automatically. But to make Creo scale the sketch with a dimension change, you have to select everything, and then modify, and then check a box for locking the selected dimension, and finally change the one dimension you want to scale everything to. This seems like a common sense item as from way back in the early Pro/E days we were taught to ignore your scale and dimensioning when you start your sketch and just make it look like what you want for a final product to extrude, then go back and start changing dimensions. Which to me is great and always has been, but it makes complete sense that if you sketch that way, finish your sketch and then want to start changing it to get to the scale you want, that the very FIRST dimension you change, you would obviously want the sketch (that you took so much time to be in the correct shape) to always scale to that. The first dimension change is the most important for your sketch to fail or turn into a shape you have no intention in using. Hope this makes sense and is being looked at also with this release or in the near future.

1 reply

Jun 20, 2016 3:52 PM UTC

Thanks for the feedback.

This is something that we're looking at, but it's not likely to make it into Creo 4.0, unfortunately.

We'll consider it for Creo 5.0.

-Raphael