Skip to main content
Jun 22, 2016 7:13 AM UTC
Question

Reusing components in mirror problem

I had problems when mirroring cylindrical component in assembly.

When "reuse selected component" evrything works fine.

1.jpg

But when "Perform symmetry analysis" is selected on completion of mirror both parts disappear. When memory is cleaned and assembly reopened I get mush like on last pic.

5.jpg4.jpg

2 replies

Jun 22, 2016 8:32 AM UTC

Hi Davor,

Thanks for sharing. I've sent it to QA to check why this was not already fixed.

Regards

Arnaud

Jun 22, 2016 9:06 AM UTC

I can confirm this is already fixed in our system build. It, unfortunately, did not make it into the Sneak Peek.