Skip to main content
Jun 18, 2016 7:23 AM UTC
Question

reference pattern feature fails in Creo 4.0

reference pattern feature fails in Creo 4.0 for a hole feature.

the reference pattern regenerates successfully,but only one hole feature( the original one) is visible. 

Model attached.

    3 replies

    Jun 20, 2016 8:46 AM UTC

    Rohit,

    thank you for the message. I have forwarded your model to QA for investigation.

    Best regards

    Jun 20, 2016 11:51 AM UTC

    Hi Rohit,

    in your case the behavior of ref pattern is similar to previous releases.

    Essentially it depends on how the hole references are being placed.

    Please refer to the attached movie illustrating the reference pattern for your case.

    best regards..

    Jun 20, 2016 12:40 PM UTC

    Thank you Martin that was good.