Skip to main content
Jul 14, 2016 6:09 PM UTC
Question

Reference Dimension check box.

Creo 4.0 interface is looking good, but I think they could add a check box for Reference dimension as they do for Basic or Inspection. It adds functioanilty and time saver.

Could I program that using Tool Kit?

    9 replies

    Jul 15, 2016 2:58 PM UTC

    The ability to add tolerances to reference dimensions would be helpful as well.

    MSavAuthor
    Jul 15, 2016 5:40 PM UTC

    Dan,

    Tolerance on a Reference Dimension may go against the purpose of a Reference dims, and I don't think is permitted by ASME practices. I may be wrong.

    For special cases, we should not have any road blocks to create a custom dimension.

    Yes Reference Dimension with tolerance.

    Jul 15, 2016 5:48 PM UTC

    Although it is not normally done, often it is handy information to have on a drawing when a part is made to a particular tolerance and you want to show that tolerance for information on a part that is made from the original part.

    I currently create a standard dimension, add the tolerance, and add parentheses to denote it as reference.

    Jul 18, 2016 12:57 PM UTC

    Currently "regular" dimensions and "reference" dimensions are separate commands.

    In the future we'd like to have only one type of dimension with an attribute that determines whether it is "regular" or "reference", but unfortunately we didn't get the chance to do that in Creo 4.0.

    We will consider that for Creo 5.0.

    Since these are different dimension types, I don't believe it would be possible to change from one to the other via Toolkit.

    MSavAuthor
    Jul 18, 2016 5:25 PM UTC

    Correct they are separate commands. But that is not quite the issue.

    Currently as you create a Reference dimension, you get a dim like this "X.XXX REF" instead of (X.XXX).  That suffix "REF" is the problem. I don't think it is even part of ASME. I can't use "REF" in my drawings.

    That you be great to have a true Reference dimension with ( ).

    Also anywhere you click on the current Dimension Tab is crashing the Creo 4.0

    Jul 18, 2016 5:42 PM UTC

    This is a config setting.  See parenthesize_ref_dim yes

    Edit:  I would argue that "yes" should be the default value since the pictures in the GUI show parenthesis.