Skip to main content
Aug 3, 2016 4:27 PM UTC
Question

Opening files in Creo 3

From the PTC Creo "Read this First" Document

the Second bullet point says

  • Data created is not supported in past nor will be supported in future releases. Files created in Sneak Peek cannot be opened in PTC Creo 3.0 or in PTC Creo 4.0 F000 (first customer ship).

however after creating some (albeit basic) geometry I was able to open it in Creo 3.0 M060. I did have the unit system change back to Creo default on me, but otherwise I'm able to edit the assembly, and the models. One of the sets of models was a family table as well. I found this out by fluke as I opened the old version when I was talking to someone and opened up my test models.

Has anyone else experienced this? or is the statement above more of a "Thou shalt not" type of statement more than "you physically cannot"