Skip to main content
Jul 21, 2016 11:21 PM UTC
Question

Is it possible to Optimize Lattice features?

Hello,

Whenever I define Lattice features, I usually cannot run it with the full geometry in Creo Simulate because AutoGEM chokes on the geometry, and when I use the Simplified Geometry, and run a sensitivity analysis, I routinely (not every time, but most times) get any one of the following errors below and the run crashes:

Error updating parameters:

The requested shape change failed because it results in

the deletion of the highlighted geometry. This geometry has

an association that cannot be deleted.

** Warning: Unable to recover from invalid design point

           for the following parameter values:

Error updating parameters:The requested shape change failed because it results inthe deletion of the highlighted geometry. This geometry hasan association that cannot be deleted.

Error: The highlighted element edge i snot associated with the highlighted curve.  You should examine this region of your model for potential modeling errors.

The model is a simple cantilevered beam with a shell feature, and a lattice inside.

If you'd like to test it out, open the attached prt file, try to mesh it and you'll get the error.  Or, try to create a sensitivity study, with dimension d4 as the variable, and change it from 1-5.  In both cases, you should get the same errors.

Capture.PNG

1 reply

Jul 27, 2016 6:43 PM UTC

Hello Senbore, the process should work when you get the Creo 4.0 FCS cd image, as you know we were testing a Beta system. In any case, I will test your model with a more recent system build and let you know the result.

Thanks a lot

Jose