Skip to main content
Jul 15, 2016 4:27 PM UTC
Question

Import Image discussion

I was glad to hear that we were going to be able to import images (jpeg, pdf, etc) into drawings finally WITHOUT using OLE. 

I just tried importing two jpegs (207 KB and 115 KB) into a drawing in Creo 4.   I saved the drawing and the resulting drawing file was 10 MB.   I think someone forgot to maintain the jpeg compression after reading it in.   I'm just guessing, but that is a logical conclusion.   That is exactly the same problem that OLE has had; it converts everything to a bitmap and stores it in the drawing file as actually two copies of the bitmap.   It makes for HUGE drawing files when you want to use pictures or imported PDFs in a drawing.   It appears as if the same is still true.

The message that I would like to emphasize to PTC is simple.   Store the imported image in the Creo drawing in the compressed format that was originally there upon import.   DO NOT convert to a bitmap and store it in that HUGE format.   It makes for HORRENDOUSLY large drawing files.

What is everyone else's take on this subject?   Do you have the need to import vendor drawings to your format?   Or do you make drawings with lots of photographs (to meet Agile needs)?  Do you care that the image file outside of Creo is tiny, but once imported is HUGE?

3 replies

Jul 15, 2016 5:54 PM UTC

I need sometimes to insert logos from small images. Yes it makes the drawing files extremely large. Yes compress those images to small Kilobytes on the import.

Jul 18, 2016 2:12 PM UTC

That's a good point.

I'll pass this along to the team so we can look at why the file sizes are getting so large.

Jul 21, 2016 1:18 PM UTC

Hello David.

Yes, we also have the need to import image files into 2D drawings. Examples are supplier catalog pages, purchased hyd valve schematics, etc.

I found similar results with an image of one of our purchased tires. The jpg itself was 28kb on disk yet the drawing file size was over 400kb. I saved the cp4.drw as a Creo View pvz and it worked . The pvz had the image file of the tire.

I then embedded a 16kb excel file to a second sht and the drw file size jumped to 529kb. With the excel file I was able to embed and then edit within the drw. Saved the drw then tried to edit the excel file again. This time I recv'd a pop-up, "OleError, Object activation failed". I erased the drw from session, retreived it again and this time was able to edit the excel file in the drw with no error messages.

Have you been able to print a cp4 drw with an image to a postscript copier? I've tried a couple different times with no output. The printer status hangs on "spooling"