Skip to main content
Sep 5, 2016 7:31 AM UTC
Question

Edge snap in cliped model

When using sketcher there is edge/geometry snaping for auto generating references. But this does not work if sketcher plane goes trough model, when "clip model" is on.

Is there a plan to implement this? its basicly snaping to take Xsec references.

1.jpg2.jpg

1 reply

Sep 7, 2016 8:53 PM UTC

This is an intended limitation. The new clipping functionality is only a graphical effect and does not actually create a geometric intersection with the solid. Thus, there are no geometric entities at the intersection that can be referenced by a snap. Stable regeneration of the sketch would require geometric entities with stable ID's at the intersection.

You would have to create a curve by cross section or an intersection curve to get what you're looking for here.