Skip to main content
Jun 15, 2016 2:15 PM UTC
Question

Does PTC Creo Parametric 4.0 also support model 'updates' to Keyshot like the 'update' command from the Keyshot Plugin?

In the demo and in the creo 4.0 interface I only see the possiblity to export to .bip and no update functionality.

Or will there still be a Keysho plugin for Creo 4.0?

Situation:

Appearances are already applied to the model in Keyshot

A change is made to the model in Creo

The model in Keyshot should update to reflect these changes, but keep the appearances defined in keyshot.

4 replies

Jun 15, 2016 2:24 PM UTC

Hi Keon,

At this time the update command is not included in the integrated mode.  This will be something I will speak with Luxion about, however, I can't comment further on it at this time.  If I have additional news, I will update this post with my views.

Regards,

mark

Jun 15, 2016 3:45 PM UTC

I'm not sure to understand perfectly you problem. I just made a test loading a part in Creo 4, I click the render button that exports to Keyshot. Then I make a dimensional change in the part, click update and it updates as it did on previous Creo versions.

I didn't install any plugin, I just used the same config.pro as in Creo 3.

Jun 16, 2016 8:22 AM UTC

To my knowledge the Keyshot Tab is not 'default', so you are probably using the Keyshot plugin for PTC Creo Parametric 3.0 inside of 4.0.

Try using no config, then the plugin will not be loaded.

or

Try using no custom *.ui file, then this Keyshot tab will not be present in the interface.

Jun 16, 2016 8:30 AM UTC

In fact, I'm using the same Keyshot plugin since Creo 2. And the tab is defined in my *.ui file as you said.

It was just to tell you do not need a new plugin file. At Luxion the plugins for Creo 3 don't support my Keyshot version (Keyshot 4). Specific Creo 3 plugins are designed for Keyshot 5.