Skip to main content
Jun 20, 2016 2:42 PM UTC
Question

Creo Parametric 4.0 exits when try to create and place a general view

Hi all, when I try to create and place a general view in drawing mode, Creo Parametric 4.0 exits automatically , I don't know whether this is a bug or not, can this issue be reproduced on your machine? Thank you.

4 replies

Jun 20, 2016 4:01 PM UTC

I'm not sure why this is happening.

Does it work for any model you create? or is it with a specific model? Is the model created in the Sneak Peek version or is it retrieved from an earlier release? Are you using a drawing format with this drawing? Try it with an empty drawing with no format.

You can also try running Creo from a clean directory with no config.pro and no UI customizations to see if something in your configs is causing the issue.

udynaAuthor
Jun 21, 2016 1:37 PM UTC

Hi RaphaelCNascimento,after without loading config.pro file, this issue was resolved now. If PTC can provide a specific tool to find which config.pro option cause exit, it will be more helpful for us.

thank you very much

Jun 21, 2016 2:55 PM UTC

Hi, Can you share your config.pro so that QA can investigate?