Skip to main content
Jun 13, 2016 6:17 PM UTC
Question

Creo 4.0 - Installed but won't start

Attempting to run the Creo 4.0 sneak peek.  The software seems to have downloaded and installed fine, but won't run. No xtop.exe process is started, or anything else as far as I can tell.  The Modelcheck dialog works fine and Creo 3.0 M080 still runs fine.  Any ideas?  (Jim Barrett-Smith‌)

    3 replies

    Jun 14, 2016 10:25 AM UTC

    Tom

    From my documents can you please send me pim_installmgr.log and the parametric.psf file so that I can check the installation was indeed successful.

    I am assuming you have read the Read This First and your graphics card and driver is in conformance

    thanks

    Jim

    TomUAuthor
    Jun 14, 2016 12:32 PM UTC

    Yes, I've read it.    My video card and driver currently support OpenGL 4.4.  Other files are attached.  Thanks.