Skip to main content
May 20, 2016 4:07 PM UTC
Question

Application SIMULATE is not available or supported on this platform.

When I try to launch Creo Simulate in Integrated mode from Parametric, the message bar says "Application SIMULATE is not available or supported on this platform."  I also launch Creo Simulate in standalone mode and whenever I open a part it immediately opens and closes so I cannot use the software.

I already checked that the application is installed and licensed correctly.

Has anyone else experienced this? Is there a fix to this?

Thanks.

4 replies

May 28, 2016 8:31 PM UTC

Senbore, apparently is not installed properly, a few options:


1.- Go to the installation point and check the Simulate folder (for example, C:\Program Files\PTC\Creo 3.0\M090\Simulate).  Is there a bin folder there?  If not, the installation was not completely successful. 

2.- You may want to try disabling antivirus and firewall and also installing at a location without any spaces.


3.-See the articles:

https://support.ptc.com/appserver/cs/view/solution.jsp?n=CS22252

Thanks a lot

Jose

osenboreAuthor
May 31, 2016 6:08 PM UTC

1. Yes, there is.  The bin folder is there.  I compared it to the bin folder from my Creo 3 install and it seems to have all the contents there.  I checked the size of my Creo 4 beta download again and it downloaded everything completely.

2. I did that and it still did not work.

3. I am having trouble uninstalling the software so I can reinstall it.

May 31, 2016 6:16 PM UTC

Hi with the  May 5th build there was an issue with the uninstall.  This has been resolved in the latest build.

thanks

Jim