Add a Construction Point on a specific X,Y,Z using the Global CSYS as reference
The intent of this Product Idea submission is to propose an Enchancement for the CreoView Visualization product and it is linked
to the PTC Case #11810399.
To provide more details in regarding to this request:
we would like to see implemented in CreoView a new feature which would allow the creation of a Construction Point using an Offset from the Global CSYS Reference (X0, Y0, Z0). this is something which is not possible at this point of time; The option offset in the Contruction point creation Panel is always Grayed out unless an already existing CSYS is selected.
Picture Below shows the Current (CV 3.0) Construction Point Panel; the offset fieds are greyed out unless an existing csys is selected .

Our request would be to enable within this panel the option to select the Global CSYS (X0, Y0, Z0) so that it would be possible to add point at an arbitraty X,Y,Z Location.
Please note:
as stated in the PTC Case already mentioned, our end users reported that in the ProductView 7.0 release this functionality was available but with the roll out of the 9.1 it was taken away. We hope this enhancement request will be accepted and implemented in the next releases of CreoView.
Looking forward to get your feedback.
Thanks
