Skip to main content
Sep 20, 2021 4:40 PM UTC

Tool Design/Mold Analysis Tips & Techniques Session Recording (West Coast)

Check out this video on Tool Design/Mold Analysis from PTC Application Engineers

Presenters: Lee Goodwin (Technical Specialist, Principal) and Lino Tozzi (Technical Specialist, Fellow)

Original Date Presented: September 14, 2021


To dive deeper into the subject, check out PTC University.

 

1 reply

Sep 21, 2021 2:23 PM UTC

Webcast Q&A

Question from Jon:  I'm a member of ASME Y14.8 Castings, Forgings and Moldings.  Would you have any recommendations pertaining to the standard:  good or bad symbols?  Useful concepts such as datum targets?  Short comings to be addressed?

Answer:  I am assuming this is for detailing purposes.  At this moment we support up to ASME Y14.5.