Skip to main content
Oct 14, 2020 2:59 PM UTC
Archived

Use Geometry rep instead of automatic rep for export to PVZ in Creo

Related products:Creo Parametric

We are using the Automatic Rep since upgrading to Creo 5, particularly when PTC by default hides the pre-Creo 4.0 Geometry and Graphics simplified representation.

We are experiencing that components in this Automatic Rep are not visible in the PVZ exported from Creo when the master rep is not in session. It is therefore not possible to open a model in a user defined representation and export to PVZ, when the user defined representation uses Automatic Reps.

Consequently, when you open a model only in the Automatic representation available in Creo, not a single component contains any geometry in the PVZ. Again, only when the master rep is not in session.

Using the option hide_pre_creo4_reps I could see that parts that where in e.g. geometry rep where actually exported to the PVZ, even if the master rep was not in session, so this effect is only seen on the Automatic rep.

Shouldn't an export to PVZ at least use the geometry rep of every visible component in the assembly ?

1 reply

olivierlp
Community Manager
Jan 3, 2025 2:41 PM UTC
Status changed to: Archived

Hello,

We are archiving your idea as part of a general review. This action is based on the age of your idea and the total number of votes received, as per this announcement.

You can always post a new idea with all the details required in the form.

Thank you for your participation.

Olivier