Skip to main content
May 3, 2013 9:03 AM UTC
Archived

Trajectory Rib feature for open geometry

Related products:Creo Parametric

I would like to crete Trajectory Rib feature for open geometry - at this moment it is only possible create this feature for closed boundary - see discusion here

Regards,

Vladimir

4 replies

3-Newcomer
May 3, 2013 12:24 PM UTC

I'd add to this that it would be helpful to be able to designate endpoints as termination points. 

Currently all open ends are either trimmed or extended to the outer part walls.  In some cases the user may want the rib to terminate inside the part or there may not be an outside wall, as in the discussion above.  Being able to to designate an open endpoint as the end of the rib would allow both of these use cases.

May 3, 2013 12:29 PM UTC

Thanks Doug, for your post

Regards,

Vladimir

Mar 16, 2019 2:28 AM UTC
Status changed to: Archived
Mar 16, 2019 2:32 AM UTC
Status changed to: Archived