The input of boundary conditions (Live Simulation) using a table or graph (time-dependent)
1. Describe the Problem
In contrast to scientific investigations in a theoretical environment, the development engineer is certain of a reasonably accurate representation of the environment. It is not enough to have fixed values for the boundaries; reality usually works with time-dependent influences (frictional heat, pressure peaks, heat shocks, temperature fluctuations day/night, etc.).
This option is available in Creo Simulate, and the logical step would be to make it available in Live Simulate as well.

Unfortunately, the value marked in red cannot be controlled by parameters or any other time-dependent value. An improvement to Live Simulate so that the input values can be controlled like in Creo Simulate would really be an enhancement. You can take the idea further and attach it to the analysis tool to allow automatic optimizations to run (especially considering the significantly faster GPU computing time). This improvement would easily double the value of Live Simulation.
2. Are you using a workaround?
Unfortunately, no emergency solution has been found so far
3. What is the use case for your organization?
Calculations of pressure and heat socks in gas
4. What impact does this problem currently have on your organization?
The benefit of Live Similar is therefore very limited, which is a shame when you see its potential.
