Skip to main content
Jul 6, 2016 6:34 AM UTC
Archived

The drawing setup option half_section_line allows to set centerline but its length cannot be changed

Related products:Creo Parametric

The drawing setup option half_section_line allows to set centerline but its length cannot be changed.

I should be possible to change the length of the centerline.

3 replies

Jul 6, 2016 2:12 PM UTC

Clarifying question, are you looking to change the offset from the edge of the geometry to the end of the line in a global manner (i.e. a dtl setup option saying 'where it is usually 1/2 inch, I'd like 1 inch') or to have the ability to drag the ends?

grichterAuthor
Jul 6, 2016 2:18 PM UTC

Thank you Matthew.

I´m looking to change the offset from the edge of the geometry to the end of the line in a global manner (i.e. a dtl setup option)

olivierlp
Community Manager
Jan 4, 2022 3:35 PM UTC
Status changed to: Archived

Hello,

We are archiving your idea as part of a general review. This action is based on the age of your idea and the total number of votes received, as per this announcement.

You can always post a new idea with all the details required in the form.

Thank you for your participation.

Olivier