Skip to main content
Nov 4, 2013 8:07 AM UTC
Archived

Strategy when pulling - Automatic (Add / Remove)

Related products:Creo Parametric

Additional selection possibility. (To change with the tab key)

Strategy by setting user:

  • Default behavior -> Geometry in the material --> Remove
  • Advanced behavior -> Greater proportion of the geometry in the material -> Remove                                                                                                                                   -> Larger proportion of the geometry outside of the material -> Add

3 replies

Nov 18, 2013 6:38 PM UTC

I don't like the current rules for Automatic (add or remove), and I don't think that any of your proposed changes would be much better. I would prefer to go back to specifying add or remove by picking different commands since seldom do I not know which I want to do when I start the command. The workaround that I have now is to create customization to start the Linear Pull command with either the Add or Remove material options set.

Dec 4, 2013 10:53 AM UTC

i use the tab key to switch between add or remove material, but unfortunatly the command always restarts from zero again. it would be an improvement if the already apply value would remain.

Mar 17, 2019 2:50 PM UTC
Status changed to: Archived