Skip to main content
Dec 17, 2012 10:08 PM UTC
Archived

Smart motion type on the Move tab during mates

Related products:Creo Parametric

When mating parts to an assembly, sometimes you need to translate, rotate, orient mode, and/or adjust.

When 5 of the 6 degrees of freedom have been fixed by the defined mates, could the move tab realize that and automatically adjust so that if you need to rotate a feature (need to have a large difference in angle for angle align) that rotate is selected versus translate.

Or if the last desgree of freedom is fixed on an axis that it would default to translate.

Thanks, Dale

4 replies

Dec 18, 2012 5:53 AM UTC

I'm still trying to figure out how to make a mechanism mate consider itself fully contrained.

It is a real bother having to constantly regenrate the assembly just to be able to save it just becasue I dragged a component or ran the motion profile.

Dec 18, 2012 5:56 AM UTC

I also had trouble adding a constant angle to a pinned component.  It only offered distance or coincident.  I wonder if this limitation is a related oversight.  It follows all logic; just doesn't provide the option.

Dec 18, 2012 12:55 PM UTC

Is one of your constraints  - Insert? If not, I am not sure you can you and constant angle constraint. I find that old component that had two cylindrical surfaces mated, will not allow constant angle whereas if I delete the mate and change it to insert, it works.

Mar 16, 2019 2:03 AM UTC
Status changed to: Archived