Skip to main content
May 31, 2024 5:02 PM UTC
Duplicate

Save a Copy and Open

Related products:Creo Parametric

It would be highly beneficial to instead of only having the option to Save a Copy, but to also open that new copy at the same time.

 

Very often I would like to make a new part that is a modification of a released part. To do that I Save a Copy, then I have to make sure I capture the new part number that was generated. Then I have to go into my workspace and find that part, and finally open the part so I can start my modifications. If I forget to grab that generated part number before I go off and do something else, then I have no hope of finding that part again later and I just make a new copy.

 

But if there was an option to Save a Copy and Open, I can get to work faster and don't have to worry about getting distracted and missing the generated part number.

2 replies

May 31, 2024 5:19 PM UTC
AndrewK
Community Manager
Jun 1, 2024 2:32 PM UTC
Status changed to: Duplicate