Retain feature settings for use within same model or session.
1. Describe the Problem
We spend a lot of time selecting the same settings within the Creo due to the fact they revert back to the default when the feature is closed. In most, if not all cases the default is not used which forces us to re-pick all settings for the next use of that feature. If all settings, you modify were to be retained until you change them or at the least until the file is closed, we would be able to reuse that feature as intended. This would eliminate many clicks throughout the day. This is a common approach with other software and actually is sometimes the case within Creo (Round dimension is saved until changed).
One example would be the steps below to create a hole for an insert. Once the hole tool is closed these settings are reverted back to default. Often, we reuse the size or one close with most settings the same.
1. Select hole button,
2. Select standard,
3. Select countersink,
4. Select hole type using hole template,
5. Select screw size,
6. Select depth,
7. Select shape pulldown,
8. Modify countersink angle,
9. Modify drill tip angle,
10. Modify thread depth.
2. Are you using a workaround?
If I know there is an existing hole, I will often use copy and paste special. This helps but even then, I have to 1. pick hole, 2. select paste special, 3 de-select dependent, 4, Select OK, 5. constrain hole. With paste special the de-selection of dependent would be another example of the setting not sticking. Also, if I use any other tool the paste special then grays out and I have to find the hole again and repeat the process to copy/paste. I know there are patterns and other ways to reduce the creation of new holes but there are a lot of instances where that is not feasible and retaining settings would save a lot of time modeling time.
3. What is the use case for your organization?
In discussion within my organization this enhancement would be used by all every day to reduce time spent setting up features.
4. What impact does this problem currently have on your organization?
All users that create features requiring setting changes are impacted. In a lot of cases this would reduce hours of work per week for everyone using Creo for part/assembly modeling.
