Skip to main content
May 12, 2014 6:55 PM UTC
Under Consideration

Replace by Copy should work for subassemblies

Related products:Creo Parametric

Replace by copy is currently only available for parts.  It is grayed out for subassemblies.  This functionality should be extended to allow subassemblies to be replaced with a copy.  When replacing a subassembly you should be given a dialog box similar to file, save a copy which lets you either copy or reuse the components of the subassembly.

21 replies

Jan 8, 2016 1:07 AM UTC

This is especially relevant to model based definition where a simple change could potentially un-place all annotations.

Jan 8, 2016 3:00 PM UTC

What you could do, for not loosing everithing:

     Open the sub assy and make a family table with one member ( the new sub assy), do not save the original model.

     Go to the top assembly, replace by the family member

     Delete the family table in the original model

You're done

Jan 15, 2016 2:24 PM UTC

Another scenario comes to mind relevant to cabling:

I have an assembly with subassemblies A and B. Subassembly B has a Shrinkwrap of subassembly A (for cabling, Top Down Design, etc.).

If I do a Save As of subassembly A to subassembly C, and replace A with C in my top level assembly, the Shrinkwrap in B still points to A.

Apr 8, 2016 11:33 AM UTC

One issue with the family table option. If you delete the family table the assembly that you swapped out in is still looking for the family table in order to pull up the new instance the assembly needs.

Jun 14, 2018 6:18 PM UTC
Status changed to: Acknowledged
Oct 24, 2018 10:53 AM UTC

I NEED THIS!!!

Feb 27, 2020 1:07 PM UTC

Idea is almost six years old and has 73 votes now.

 

Can we get an update on when this will be implemented?

Jun 30, 2020 8:34 AM UTC
Status changed to: Under Consideration

We are reviewing  this solution.

 

By the way, there is a work around:

  • Save a copy of the assembly
  • Replace by Unrelated Component
    • or make an external interchange assembly
  • Edit Ref Table and map by "Same History" rule
    • or manual mapping
Sep 10, 2020 12:46 PM UTC

I need this option to work.

Didn't this work many years ago?

I've been using PTC for 23 years now and I thought I was able to do this on assemblies in the past.

Feb 11, 2022 5:18 PM UTC

I see this is "Under consideration" for more than a year and a half. Isn't there some prioritization done for functionality that is clearly supposed to be there? Worst-case, enable the check-box and dump me into the reference pairing dialog, at least that relieves me of making an interchange assembly.