Skip to main content
May 29, 2014 4:01 PM UTC
Archived

Reorienting w/ Cross Section Active

Related products:Creo Parametric

Currently when a model is reoriented and a cross section is active, Creo doesn't recognize reorienting the model about a point in the cross section by middle-clicking.  It picks some point far away (spin center?) which makes manipulating about an object in the cross section when zoomed up almost impossible since it rotates from some point far away and the entire cross section movement is multiplied by this distance. In order to manipulate something like this, you have to zoom out, rotate about some non-cross-section point, and then zoom back in. Extremely frustrating.  Just make creo recognize a point on the cross section.

2 replies

Jun 11, 2014 8:37 AM UTC

I've just discovered that this seems to work as you'd want in WF5 (M220), with spin centre off obviously.

At first I thought it was because I had Geom Rep active, but it also seems to behave correctly in Master Rep...

Can anyone confirm?  If I get an opportunity I'll test Creo 2 later.

Mar 17, 2019 3:29 PM UTC
Status changed to: Archived